It's stripping time!

First time I've used these clamps Daz and they are really good will definitely get some more for the toolbox.

All the time Voyager

I managed to complete the welding on top however only have a pic of half way through and ground it down as well.




I also added in the 2mm reinforcing plate underneath.



Still need to grind it back a bit underneath for beautification purposes Last bit is to align the seat rail with it bolted to my seat swivel to get the right position and weld it in.

This is the seat rail tacked in I have already removed the seat swivel ready for final welding.



Final welding of seat rail


Onto primer, seam sealer, paint, stone chip and then refit everything.

@Skytiger wrote:

Onto primer, seam sealer, paint, stone chip and then refit everything.

Not much then!

Great work, keep it up

Jobs a good un

Underneath now primered and seam sealed just stone chip to finish


Inside now primered, going to leave it like that so I can use my kombi and apply a topcoat later. You can see just a few rust bits at bottom left of pic will sort them also then paint all bits at the same time.

It doo look better - keep up the good work

Thanks guys, stone chip now done, Phileas is ready for action again

Looks very good

Looks great - let the next adventures begin

On same job and trying out new bead roller

Bead rolling looks great, how easy was it to use the machine?

@Skytiger wrote:

Bead rolling looks great, how easy was it to use the machine?

Very easy:)